Agilent 4155C/4156C User’s Guide Vol.1, Edition 11 5-35
Print/Plot Function
Saving Measurement Data Graphs
5. If you select HR PCL, HR TIFF or HP-GL, set the GRAPH TRACE ONLY field
by selecting YES or NO softkey.
YES Graph trace only output.
NO Outputs the graph information enabled on PRINT/PLOT
SETUP screen OUTPUT ITEM fields.
6. Set the PRINT SETUP DATA field by selecting YES or NO softkey.
YES Graph output with setup data.
NO Graph output only.
If you select YES, set the POSITION entry field. (For the PCL mode, the
POSITION field is not displayed and is always set to BOTTOM.)
BOTTOM Places the setup data below the graph.
RIGHT Places the setup data to the right of the graph.
7. If you select HR PCL or HP-GL, set the OUTPUT REGION. There are two
available fields:
UPPER LEFT Specifies the position of the upper-left corner of the printed
or plotted hard copy.
LOWER RIGHT Specifies the position of the lower-right corner of the
printed or plotted hard copy.
Select one of the following softkeys, or enter a value using the keyboard or the
ENTRY keys on the front panel. These softkeys are available for each OUTPUT
REGION field:
WHOLE Sets the output region as the entire sheet.
UPPER LEFT Sets the output region to the upper-left quarter of the
paper.
UPPER RIGHT Sets the output region to the upper-right quarter of the
paper.
LOWER LEFT Sets the output region to the lower-left quarter of the
paper.
LOWER RIGHT Sets the output region to the lower-right quarter of the
paper.
STORE REGION Stores the OUTPUT REGION settings in the internal
memory.
RECALL REGION Recalls the latest settings stored in the internal memory.
To Next Page
Loading...
Need help?
General
