5-34 Agilent 4155C/4156C User’s Guide Vol.1, Edition 11
Print/Plot Function
Saving Measurement Data Graphs
In this dialog box, three softkeys are available:
PRINT/PLOT Executes the file save.
PR/PL SETUP Displays the PRINT/PLOT SETUP screen. To close the
PRINT/PLOT SETUP screen, select EXIT softkey.
EXIT Closes the GRAPH PLOT dialog box and quits the
print/plot function.
2. To set the DESTINATION to FILE, select FILE softkey.
3. Enter the file name into the FILE NAME entry field.
To save a file to a diskette, the file name must be:
• a maximum of 8 characters for DOS format
• a maximum of 6 characters for HP LIF format (Do not use "_" as the last
character of the filename.)
To save a file to the network drive, the file name can be a maximum of 36
characters. The file name and directory path can be a maximum of 58 characters.
4. To set the LANGUAGE, select PCL, HR PCL, HP-GL or HR TIFF softkey.
If you select the PCL, HR PCL or HR TIFF mode, set the RESOLUTION by
selecting one softkey: 75 DPI to 600 DPI. For more information on selecting the
resolution, see “Output Resolution” on page 5-5.
If you select the HR PCL mode, setting the resolution too low will result in poor
print quality.
GRAPH PLOT
*DESTINATION FILE
*PRINT/PLOT COMMENT
*GRAPH TRACE ONLY
NO
*LANGUAGE
*RESOLUTION
75 DPI
*PRINT SETUP DATA
YES
POSITION
BOTTOM
*FILE NAME
HR TIFF
To Next Page
Loading...
Need help?
General
