10 5000 Series Oscilloscopes Service Guide
Figures
Figure 24. Disconnecting the display cables (bottom view of
scope) 92
Figure 25. Removing the display assembly 93
Figure 26. Installing the display 94
Figure 27. Opening the backlight inverter shield 95
Figure 28. Removing the backlight inverter 96
Figure 29. Removing the backlight inverter shield 97
Figure 30. Closing the shield 98
Figure 31. Release display mount latches 99
Figure 32. Removing the LCD, gasket, and protective lens 100
Figure 33. Latch over face of sheet metal housing 101
Figure 34. Removing the power shaft latch 102
Figure 35. Removing the AC input board 103
Figure 36. Removing the power supply 105
Figure 37. Locating and disconnecting fan cable 106
Figure 38. Removing the fan 107
Figure 39. Preparing to remove the system board 109
Figure 40. Removing the system board 110
Figure 41. Exploded View 1 of 2 116
Figure 42. Exploded View 2 of 2 117
To Next Page
Loading...
Need help?
General
