DECLARATION OF CONFORMITY
According to ISO/IEC Guide 22 and CEN/CENELEC EN 45014
Manufacturer’s Name:
Agilent Technologies, Incorporated
Manufacturer’s Address:
Supplier’s Address:
5301 Stevens Creek Boulevard
Santa Clara, CA 95051
USA
Declares under sole responsibility that the product as originally delivered
Product Name:
5530 Dynamic Calibrator
Model Number:
E1735A USB Axis Module, E1736A USB Sensor Hub,
E1737A Material Sensor, E1738A Air/Temp/Hum/Pres
Sensor
Product Options:
This declaration covers all options of the above products
Complies with the essential requirements of the following applicable European Directives,
and carries the CE marking accordingly:
• The Low Voltage Directive (2006/95/EC)
• The EMC Directive 89/336/EEC, amended by 93/68/EEC
Conforms to the following product standards:
EMC Standard Limit
IEC 61326-1:2002/EN 61326:1997+A1:1998+A2:2001+A3:2003
CISPR 11:1990 / EN 55011:1990 Group 1 Class A
IEC 61000-4-2: 1995+A1: 1998 / EN 61000-4-2:1995 4 kV CD, 8kV AD
IEC 61000-4-3: 1995 / EN 61000-4-3: 1996 3 V/m, 80-1000MHz
IEC 61000-4-4: 1995 / EN 61000-4-4: 1995 0.5 kV signal lines, 1 kV power lines
IEC 61000-4-5: 1995 / EN 61000-4-5: 1995 0.5 kV line-line, 1kV line-ground
IEC 61000-4-6: 1996 / EN 61000-4-6: 1996 3 V, 0.15-80 MHz 1 cycle, 100%
IEC 61000-4-11: 1994 / EN 61000-4-11: 1994 Dips: 30% 10ms; 60% 100ms
Interrupt: > 95%@5000ms
Canada: ICES-001: 2004
Australia/New Zealand: AS/NZS CISPR 11: 2004
This product was tested in a typical configuration with Agilent Technologies test systems
Safety
IEC 61010-1:2001 / EN 61010-1:2001
Canada: CSA C22.2 No. 61010-1-04
Supplementary Information:
This DoC applies to above-listed products placed on the EU market after:
25 August 2008
Randall White
Date
Randall White
Product Regulations Manager
For further information, please contact your local Agilent Technologies sales office, agent or distributor,
or Agilent Technologies Deutschland GmbH, Herrenberger Straße 130, D 71034 Böblingen, Germany.
To Next Page
Loading...
Need help?
General
