Chapter 3 Installing the Software and Connecting Components
Connecting the Sensors
Getting Started Guide 3-13
3
Figure 3-10. The Sensor Hub sensor ports
To connect a sensor cable to the hub, line up the red mark on the cable
connector with the small circle above the connector port on the Sensor
Hub (see Figure 3-10).
CAUTION Do do not twist or turn the connector while inserting it. This may damage
the pins inside of the connector.
The cable connector includes a spring-loaded locking mechanism to hold
the cable securely to the Sensor Hub. To disconnect the cable, release the
lock by sliding back the knurled sleeve on the connector. The cable
connector should disconnect easily from the Sensor Hub.
1 - 4 Sensor connection
ports
5 Agilent E1736A USB
Sensor Hub
6 Cable connector
alignment mark (x4)
5
Agilent Technologies
E1736A
USB Sensor Hub
1
2
3
4
Sens
or
#4
Sensor
#3
Sens
or
#2
Sensor
#1
6
To Next Page
Loading...
