100
Remote Commands
The Common Commands
• Service request enable register (SRE)
• Standard event status enable register (ESE)
The commands and parameters of the reset
state are listed in the following table.
Table 8-6 Reset State (Default Setting)
Example OUTPUT 728;"*RST"
*SAV
Syntax *SAV <wsp> <location>
1
≤ location ≤ 9
Parameter Reset Value
Attenuation Factor 0dB
Calibration Factor 0dB
Wavelength 1310nm
Sweep Manual
Start 0.00dB
Stop 0.00dB
Step 0.00dB
Dwell 0.2s
Back Refl. Ins. Loss 2.00dB
RL Ref 14.70dB
RL-Input 60.00dB
λ Cal Off
User Cal Off
Through Power Mode Off
Display Brightness Full
Power On Setting Last
Shutter enable under GPIB Normal
Shutter at Power ON Disabled
Resolution 1/100
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
