116
Remote Commands
STATus Commands
Figure 8-2 The Status Registers
:STATus:OPERation:CONDition?
Syntax :STATus:OPERation:CONDition?
Description This query reads the contents of the
OPERation:CONDition register. Only three
bits of the condition register are used:
• Bit 1, which is 1 when the motor that
positions the attenuator filter is settling.
• Bit 3, which is 1 while the instrument is
performing an attenuation sweep.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
