49
Making an Attenuation Sweep
The Automatic Sweep
Figure 3-2 The Parameters for an Automatic Sweep
Starting the Setting Up
To select the automatic sweep
1. Press S
WP.
2. If it is not already set, use
⇑ or ⇓ to set SWEEP to AUTO.
Figure 3-3 Selecting the Automatic Sweep Application
Editing the Parameters
To edit the value of the parameters
3. Press S
WP again to get START.
4. Edit the value of START with the Modify keys.
5. Press S
WP again to get STOP.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
