265
Cleaning Information
How to clean instruments with a recessed lens interface
interface. The invisible emitted light is project onto the card and
becomes visible as a small circular spot.
Preferred Procedure
Use the following procedure on most occasions.
1. Clean the interface by rubbing a new, dry cotton-swab over the
surface using a small circular movement.
2. Blow away any remaining lint with compressed air.
Procedure for Stubborn Dirt
Use this procedure particularly when there is greasy dirt on the
interface:
1. Moisten a new cotton-swab with isopropyl alcohol.
2. Clean the interface by rubbing the cotton-swab over the surface
using a small circular movement.
3. Take a new, dry soft-tissue and remove the alcohol, dissolved
sediment and dust, by rubbing gently over the surface using a
small circular movement.
4. Blow away any remaining lint with compressed air.
E.15 How to clean instruments with a recessed
lens interface
WARNING For instruments with a deeply recessed lens interface (for example the
Agilent Technologies 81633A and 81634A Power Sensors) do NOT
follow ths procedure. Alcohol and compressed air could damage your
lens even further.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
