Issue 2 - 07/00 4-35
Testing in Simulation Mode - Section 2
instructions). For a self call, the CPN is the
number of the line to which aurora
Sonata
is
connected. With the ETSI protocol, you can
also select SUB and enter a sub-address if
required.
Note
If you set a new CPN here, it is used for all components of all
one-button tests.
Tip
You can use the Recall and Save function keys to access
numbers in aurora
Sonata
’s speed-dial directory (see Chapter 6
section 1).
-7-
To select the BERT pattern for the test:
• Select Pattern.
• Highlight the pattern you require and press
ENTER to close the option window.
-8-
When you have set up the test details, press
ESC to return to the Line quality component
display and ESC again to return to the main
ISDN Test Suite.
-9-
With Line quality still highlighted, press the
Go function key.
Note
During the test any incoming calls are answered automatically
and a loop applied to the relevant B channel, irrespective of
call type and answer mode settings.
To Next Page
Loading...
