aurora
Sonata
Hand Held ISDN Tester—User Guide
4-34 427869
Press ENTER if required to place a tick in the
box next to BERT.
-3-
Press the Setup function key to display the
settings for the BERT component.
-4-
To select the service for the test call:
• Select Service.
• Highlight the service you require and press
ENTER to close the option window.
-5-
To change the test length:
• Select Duration to display an option
window.
• Highlight the duration you require, or
User Defined if you wish to set a custom
duration. Press ENTER to close the
option window.
• To enter a custom (i.e. User Defined)
duration, select User Def to display an
entry window. Type a time in hours,
minutes and seconds (two digits for each)
and press ENTER.
-6-
To set the CPN for the test call, select CPN to
open an entry window and enter a CPN as
normal (see Chapter 3 section 2 for
To Next Page
Loading...
