Issue 2 - 0700 4-39
Testing in Simulation Mode - Section 3
A channel test passes if incoming and outgoing calls are
established successfully and cleared normally. It fails when
calls are not established successfully, or are cleared with
abnormal causes.
Setting up the test
For TN1R6-N and TN1R6-T, the Outgoing
Channel Test component is only available when
L3 Protocol in the Emulation menu. See
Identifying the Layer 3 master/slave in
Section 1 of Chapter 3.
-1-
Display the ISDN Test Suite. For instructions
on how to do this and general information
about the Test Suite, see Introducing the ISDN
Test Suite in Section 1.
-2-
Highlight Channel and press ENTER.
aurora
Sonata
displays a screen showing that the
Channel one-button test has Outgoing
Channel and Full Channel test components.
Press ENTER if necessary to place a tick in the
box next to each component you require.
-3-
Set up the details for the components you have
selected, as described overleaf.
To Next Page
Loading...
Need help?
General
