Issue 2 - 0700 4-41
Testing in Simulation Mode - Section 3
-4-
Enter the CPN and sub-address for a distant
test, if required.
īīNotes:
ā¢ If you set a new CPN here, it is used for all components
of all one-button tests.
ā¢ If you send the CPN, aurora
Sonata
waits for an Alerting
message (speech calls) or a Connect message (data calls)
before releasing the call. If you do not, it waits for a
Setup Acknowledge message for speech and data calls.
To set up a new CPN for the test:
ā¢ Select CPN to display an entry window.
Enter a CPN as normalāfor instructions,
see Identifying the CPN for the call in
Chapter 3 section 2.
ā¢ Select SUB if required and repeat the
process.
Tip
You can use the Recall and Save function keys to access
numbers in aurora
Sonata
ās speed-dial directory. For details on
speed-dialling, see Chapter 6 section 1.
-5-
When you have set up the test, press ESC to
return to the Channel component display.
Setting up the Full Channel test details
To change the operation of the Full Channel component:
-1-
In the Channel component display screen,
highlight Full Channel and press the Setup
function key.
-2-
Select the bearer service and the CPN, as
described for the Outgoing Channel test.
īīNote
The Full Channel test is always Distant, so there is no
Destination setting.
To Next Page
Loading...
Need help?
General
