aurora
Sonata
Hand Held ISDN Tester—User Guide
4-50 427869
Beginning the Available Services test
When you have selected the test components and set up the
test as described above:
-1-
Return to the main ISDN Test Suite.
-2-
With Available services highlighted, press the
Go function key.
Understanding the Teleservice test results
As the Teleservice component test proceeds, aurora
Sonata
displays the result (Pass or Fail) for each service being tested.
Pass means that the test call for the service was successfully
established and cleared normally. Fail means that the call could
not be established, or was cleared with an abnormal cause.
The Status bar shows the service currently being checked. In
the above example, aurora
Sonata
is checking Video.
When the test is complete, aurora
Sonata
lists the results for all
services that have been tested. It also stores the most recent set
of results for the Teleservice component—you can view this
from the Review Results menu (see section 1).
Tip
Where a service fails, you can display a description of the
Cause Code for the test call by highlighting the result line for
the service and pressing ENTER.
To Next Page
Loading...
Need help?
General
