Issue 2 - 07/00 4-57
Testing in Simulation Mode - Section 5
-4-
To enable or disable the type of Call
Forwarding you have selected:
• Select Mode to display an option window.
• Highlight Enable or Disable and press
ENTER. The option window closes.
-5-
Identify the number to which the calls are to
be forwarded. To do this:
• Select CPN to display a CPN entry
window.
• Type the number and press ENTER to save
it. The entry window closes.
• Select SUB and enter a sub-address, if
required.
Note
When aurora
Sonata
is set up to test a Basic Rate point-to
multipoint link, the Call Forwarding setup screen has a CLI
options selection, which displays the CLI/COL menu. You
must set up a CLI to test Call Forwarding.
-6-
To identify the type of call to be forwarded:
• Select Service to display a list of general
call types.
• Highlight the type of call to be forwarded,
or All Services for all call types.
• Press ENTER to save your selection and
close the option window.
-7-
Press the Send function key to send the
forwarding request to the network. aurora
Sonata
displays a pop-up window to confirm that the
network has accepted the service invocation.
Press ESC to close the pop-up window.
To Next Page
Loading...
Need help?
General
