aurora
Sonata
Hand Held ISDN Tester—User Guide
5-10 427869
Beginning a protocol monitor session
When you press ENTER to select a channel (usually the D
channel) for protocol monitoring, you are prompted to enter a
name for the session.
-1-
Enter a name (up to eight characters). For
instructions, see Entering alphanumeric
information in Chapter 2 section 3. You cannot
use the name of an existing stored session.
Notes:
• When Memory Mode is set to Fill (see Choosing what
happens when the memory is full in Chapter 3 section 1),
once the memory is full you cannot save a new session
until you delete an existing one.
• If you do not assign a name, aurora
Sonata
automatically
names the sessions M1, M2 and so on.
-2-
Press the OK function key to save the name and
begin the monitor session.
When you have set an automatic start time
When you have set up an automatic timed start for monitoring
(see Entering an automatic start time earlier in this chapter),
and you press OK to start a session, aurora
Sonata
displays the
following screen:
The Time display shows the current time. When this reaches
the displayed Start Time, the monitor session begins.
To Next Page
Loading...
Need help?
General
