Agilent Technologies auroraSonata

Issue 2 - 07/00 3-17
First Steps in Testing - Section 1
knil2reyaL
citamotuA arorua
atanoS
aekamuoynehwylnoknilehtpustes
llacehtnehwniagadesaelerebyamknilehT.llac
.deraelcsi
tnenamreP ohctiwstsrifuoynehWaroruan
atanoS
,ehtpustesti
hcaetisesudnaknilsihtpuspeektI.knil2reyaL
.llacaekamuoyemit
fIarorua
atanoS
sitinehwknilehtputestonnac
sillactsrifehtnehwniagaseirtti,nodehctiws
erutufrofknilehtpuspeekti,sdeeccus
tifI.edam
.sllac
Note
This setting also determines the point at which Layer 1
activates for a call—for details, see Activation of Layer 1 in
Chapter 4 section 2. If Layer 1 is not operating properly,
aurora
Sonata
cannot set up the link at Layer 2 level.
Selecting the way in which B channel TEIs are
assigned
For Basic Rate operation you can determine whether TEIs are
assigned by the network (Automatic) or manually (Fixed)
and, for fixed TEIs, assign one or two TEI values.
When CorNet-T and TN1R6 are selected and you are testing a
point to multipoint line, you can set up fixed TEI settings.
CorNet-N or TN1R6-N can only operate on point to point
lines, therefore you cannot set TEIs and they are set to 0,0.
-1- From the Layer 2 Setup menu, select B TEI.