Issue 2 - 07/00 3-19
First Steps in Testing - Section 1
⢠When TEIs are assigned automatically, the network
ensures that no two terminals on the link have the same
TEI. When you assign them manually, you must check
this yourself.
Setting up aurora
Sonata
to generate call charging
You can define the way in which aurora
Sonata
generates charging
information (known as Advice of Charge or AOC) and sends
it to the caller for incoming calls. This is only used when
aurora
Sonata
is emulating a Network Termination (NT).
If VN4 is selected and you are emulating a TE, aurora
Sonata
allows you to request charging information from the NT.
When CorNet-T is selected you cannot configure aurora
Sonata
as
a NT, therefore you cannot set up charging information.
If TN1R6-N and CorNet-N are selected charging information
can be generated by either the TE or NT.
îîNote
AOC is an ISDN supplementary service. For details on testing
supplementary services, see Chapter 4 section 5.
-1-
From the ISDN Setup menu, select Charging
to display the options for the selected protocol.
Mode Determines whether charging information is
sent manually or automatically.
AOC Determines the point in the call at which
aurora
Sonata
sends the information.
Message The type of message in which the information
is sent.
To Next Page
Loading...
Need help?
General
