Issue 2 - 07/00 3-27
First Steps in Testing - Section 1
To identify the CPN numbering plan:
-1-
From the Dial Options menu, select CPN
plan.
-2-
Highlight the numbering plan you require and
press ENTER. The options are:
nalPrebmuNNPC
nwonknU sinalpgnirebmunnoitanitsedehT
.nwonknu
eleT/NDSI otrefeR.nalpgnirebmunynohpeleT/NDSI
rehtrufrof361.E/461.EnoitadnemmoceR
.sliated
ataD
)T/NteNroC,ISTE(
otrefeR.nalpgnirebmunataD
.sliatedrehtrufrof121.XnoitadnemmoceR
xeleT
)T/NteNroC,ISTE(
otrefeR.nalpgnirebmunxeleT
.sliatedrehtrufrof96.FnoitadnemmoceR
lanoitaN
)T/NteNroC,ISTE(
cilbupotseilppa.e.idradnatSlanoitaN
.skrowten
etavirP
)T/NteNroC,ISTE(
.nalpgnirebmunkrowtenetavirP
devreseR
)T/NteNroC,ISTE(
.esuerutufrofdevresersisihT
Selecting the linkage type for ECT
Explicit Call Transfer (ECT) is a supplementary service where
the subscriber can connect a held call to a connected call and
then disconnect their unit, leaving the other users connected
to each other. For full instructions on how to test ECT and
other supplementary services, see Chapter 4 section 5.
-1-
From the ISDN Setup menu, select ECT.
To Next Page
Loading...
Need help?
General
