Agilent Technologies Infinity Binary Pump VL 1290 User Manual

Agilent 1290 Infinity Binary Pump User Manual 231
LAN Configuration
13
Initialization mode selection
Using Default
When Using Default is selected, the factory default parameters are taken
instead. These parameters enable a TCP/IP connection to the LAN interface
without further configuration, see Table 17 on page 231.
Figure 40 Using Default (Principle)
Since the default IP address is a so-called local address, it will not be routed by
any network device. Thus, the PC and the module must reside in the same
subnet.
The user may open a Telnet session using the default IP address and change
the parameters stored in the non-volatile memory of the module. He may then
close the session, select the initialization mode Using Stored, power-on again
and establish the TCP/IP connection using the new parameters.
When the module is wired to the PC directly (e.g. using a cross-over cable or a
local hub), separated from the local area network, the user may simply keep
the default parameters to establish the TCP/IP connection.
6Xi^kZ
EVgVbZiZg
9Z[Vjai
EVgVbZiZg
NOTE
Using the default address in your local area network may result in network problems. Take
care and change it to a valid address immediately.
Tab le 17 Using Default Parameters
IP address: 192.168.254.11
Subnet Mask: 255.255.255.0
Default Gateway not specified
NOTE
In the Using Default mode, the parameters stored in the memory of the module are not
cleared automatically. If not changed by the user, they are still available, when switching
back to the mode Using Stored.

Agilent Technologies Infinity Binary Pump VL 1290 Specifications

General

Brand	Agilent Technologies
Model	Infinity Binary Pump VL 1290
Category	Laboratory Equipment
Language	English