Agilent Technologies InfinityLab LC Series - Cleanup after abort failed; Wash procedure failed

Agilent InfinityLab LC Series Vialsamplers User Manual 208
7Error Information
Vialsampler Error Messages
Cleanup after abort failed
Error ID: 34310
This, similarly to the Command failed error events, is a non-specific error message
and indicates only that something went wrong during the cleanup procedure. The
cleanup procedure refers to the process, which is executed when an analysis is
aborted (for example, due to a missing vial) and the components of the sampler
(such as the needle, gripper arm, and the metering device) need to be reset to the
initial conditions. As for the Command failed error events, this error message is
usually also coupled with other error events, which provide more specific
information on the nature of the issue. To identify these source error events, look
for entries with the same timestamp as for the Cleanup after abort failed error
message.
Wash procedure failed
Error ID: 34314
This, similarly to the Command failed error events, is a non-specific error message
and indicates only that something went wrong during the wash procedure. It is
usually coupled with other error events, which provide more specific information
on the nature of the issue. To identify these source error events, look for entries
with the same timestamp as for the Wash procedure failed error message.
Probable cause Suggested actions
1 Cleanup procedure failed
Identify the source error message and follow the
instructions provided for that.
Probable cause Suggested actions
1 Wash procedure failed
Identify the source error message and follow the
instructions provided for that.