Agilent InfinityLab LC Series Vialsamplers User Manual 325
11 Hardware Information
Interfaces
5V Distribution (Future Use)
• Available directly after turning on the hosting module (assures that the
firmware can detect certain basic functionality of the device).
• For digital circuits or similar.
• Provides 500 mA maximum.
• Short-circuit proof with automatic switch off (by firmware).
24V Distribution (Future Use)
• Available by firmware command (defined turn on/off).
• For devices that need higher power
• Class 0: 0.5 A maximum (12 W)
• Class 1: 1.0 A maximum (24 W)
• Class 2: 2.0 A maximum (48 W)
• Class depends on hosting module’s internal power overhead.
• If a connected device requires more power the firmware detects this
(overcurrent detection) and provides the information to the user interface.
• Fuse used for safety protection (on board).
• Short circuit will be detected through hardware.
USB (Universal Serial Bus)
USB (Universal Serial Bus) - replaces RS232, supports:
• a PC with control software (for example Agilent Lab Advisor)
• USB Flash Disk
To Next Page
Loading...
