Agilent Technologies InfinityLab LC Series - TCP;IP parameter configuration

To Next Page

To Previous Page

Agilent InfinityLab LC Series Vialsamplers User Manual 334

12 LAN Configuration

TCP/IP parameter configuration

To operate properly in a network environment, the LAN interface must be

configured with valid TCP/IP network parameters. These parameters are:

• IP address

• Subnet Mask

• Default Gateway

The TCP/IP parameters can be configured by the following methods:

• by automatically requesting the parameters from a network-based DHCP

Server (using the so-called Dynamic Host Configuration Protocol). This mode

requires a LAN-onboard Module or a G1369C LAN Interface card, see

“Setup

(DHCP)” on page 339

• by manually setting the parameters using Telnet

• by manually setting the parameters using the Local Controller

The LAN interface differentiates between several initialization modes. The

initialization mode (short form ‘init mode’) defines how to determine the active

TCP/IP parameters after power-on. The parameters may be derived non-volatile

memory or initialized with known default values. The initialization mode is

selected by the configuration switch, see

Table 27 on page 336.

Other manuals for Agilent Technologies InfinityLab LC Series