Agilent InfinityLab LC Series Vialsamplers User Manual 154
4 Preparing the Module
Setting up the Vialsampler
Setting up the Vialsampler
The setup of the Vialsampler is shown with the Agilent OpenLab ChemStation
C.01.07. Depending on the controller (e.g. Agilent Local Controller, OpenLab
EZChrom, Masshunter) the screens look different.
Figure 29 ChemStation Method and Run Control
After successful load of the OpenLab ChemStation, you should see the module
as an active item in the graphical user interface (GUI).
This section describes the Vialsampler settings only. For information on the
software or other modules refer to the corresponding documentation.
To Next Page
Loading...
