152 Chapter 3
Mode
Two Port Insertion Loss Measurement
Mode
Result # Field Name Description
1–256 Insertion Loss Trace Insertion Loss trace (dB)
257 Average Insertion Loss Average Insertion Loss of the trace (dB)
258 Valid Calibration Indicates if there is a valid calibration
(0 = false, 1 = true)
259 Calibration/Measurement
Mode
8 = calibrate,
9 = measure insertion loss
(un-calibrated),
10 = measure normalized insertion loss
260 Start Frequency In Hz
261 Stop Frequency In Hz
262 Automatic Source
Amplitude
Automatically or manually set the
Source Amplitude for the sweep
(0 = manual, 1 = automatic)
263 Source Amplitude Power output of the source for the sweep
(dBm)
264 Average Type 0 = no averaging
1 = exponential average
2 = max hold
3 = repeat average
4 = repeat max
265 Num Averages Number of averages
266 Interference Mode Compensate for interference from
existing signal. Turning this mode on
will significantly slow the measurement
but improve its accuracy when
interfering signals are present.
0 = off,
1 = on
267 Optimization Mode Optimize for range or accuracy.
0 = accuracy
1 = range
268 Average Count Number of measurements averaged into
this data.
269 Time Stamp
Seconds
Time of measurement, instrument clock
seconds
To Next Page
Loading...
