176 Chapter 3
Mode
Two Port Insertion Loss Measurement
Mode
Avg Limits On/Off Turns on/off the average limit values.
Max Loss Limit Sets the maximum average limit value. If the average limits are turned on, then
the measured average insertion loss will be compared with this value.
Min Loss Limit Sets the minimum average limit value. If the average limits are turned on, then
the measured average insertion loss will be compared with this value.
Optimize
When using the default settings, the spectrum analyzer optimizes measurement accuracy
at the expense of dynamic range. There may be times, however, when you prefer to gain
dynamic range and lose some accuracy. For example, you may be making a measurement
where you want to see a relatively large dynamic range, and your results will not be
impaired significantly by 1 to 2 dB less accuracy. Optimizing for dynamic range gains you
approximately 30 dB of dynamic range.
Mode Stimulus / Response
Preset 0
Range On|Off
Key Path
Meas Setup, Avg Limits, Avg Limits On/Off
Mode Stimulus / Response
Preset 20 dB
Key Path
Meas Setup, Avg Limits, Max Loss Limit
Mode Stimulus / Response
Preset 50 dB
Key Path
Meas Setup, Avg Limits, Min Loss Limit
Mode Stimulus / Response
Remote Command
Notes
N/A. Front Panel feature only
Preset Accy
To Next Page
Loading...
