Agilent Technologies N1996A-503 - Page 178

178 Chapter 3
Mode
Two Port Insertion Loss Measurement
Mode
Peak Search
Accesses the marker peak functions and places a marker on the highest peak of the
currently selected trace.
Next Peak
Places the selected marker on the next highest signal peak from the current marked peak.
Source
Sets the RF power output level of the internal instrument source
Mode SR
Remote Command :CALCulate:TPILoss:MARKer[1]|2:MAXimum
Example :CALC:TPIL:MARK2:MAX
Key Path Front-panel key
Mode SR
Remote Command :CALCulate:TPILoss:MARKer[1]|2:MAXimum:NEXT
Example CALC:TPIL:MARK2:MAX:NEXT
Key Path
Peak Search, Next Peak
Mode Stimulus / Response
Remote Command :SOURce:TPILoss:POWer[:LEVel][:IMMediate][:AMPLitude]
<power>
:SOURce:TPILoss:POWer[:LEVel][:IMMediate][:AMPLitude]
?
:SOURce:TPILoss:POWer[:LEVel][:IMMediate][:AMPLitude]
:AUTO OFF|ON|0|1
:SOURce:TPILoss:POWer[:LEVel][:IMMediate][:AMPLitude]
:AUTO?
Restrictions and Notes The range of settable power values depends on the Agilent CSA
model. Using the Source in Auto mode will automatically check if
the actual power level is achievable for the frequency range set
for the measurement.