Chapter 3 181
Mode
Two Port Insertion Loss Measurement
Mode
View/Display
The following View/Display keys are for setting up a Two Port Insertion Loss measurement.
The measurement must already be running to access these keys. Press
Meas, Two Port
Insertion Loss
to turn on the measurement.
Avg Insertion Loss
Sets the Average Insertion Loss setting to either On or Off.
Remote Command :TRACe[1]|2:TPILoss:DISPlay[:STATe] ON|OFF|1|0
:TRACe[1]|2:TPILoss:DISPlay[:STATe]?
Example TRAC2:TPIL:DISP 1 Makes trace 2 visible
TRAC2:TPIL:DISP 0 Blanks trace 2
Dependencies / Couplings • Setting the trace type (even to the type it was already in)
puts the trace in
Show
• Loading a trace from a file puts that trace in Show
regardless of the state it was in when it was saved.
Remote Command Notes Display On = Show, Display Off = Blank
Preset
Show for Trace 1; Blank for 2
State Saved saved in Instrument State
Key Path
Trace/Detector, Display Show/Blank
Mode: All
Key Path Front-panel key
Mode Stimulus / Response
Preset On
Range On | Off
Key Path
View/Trace, Avg Insertion Loss
To Next Page
Loading...
