Chapter 3 189
Mode
One Port Insertion Loss Measurement
Mode
previous trace data. Pressing the Max Hold key for the selected trace sets the trace type to
Max Hold, causes the trace to be cleared and causes the Max Hold sequence to be restarted.
Repeat Sets averaging to the repeat function. Repeat averaging updates the trace after the
selected number of sweeps has been averaged. It is not updated again until the next set of
data from the Avg Number of sweeps has been collected.
Repeat Max Hold Sets averaging to repeat with max hold function. Repeat with max hold
captures and holds the highest magnitude data at the end of each sweep count. Repeat
with max hold updates the trace after the selected number of sweeps has been made. It is
not updated again until the next set of data from the Avg Number of sweeps has been
collected.
Avg Number
Sets the number of measurement averages used when calculating the measurement result.
Clear Calibration
Clear Calibration deletes the current calibration data.
Key Path: Meas setup, Avg Mode, Max Hold
Key Path: Meas setup, Avg Mode, Repeat
Key Path: Meas setup, Avg Mode, Repeat Max Hold
Mode Stimulus / Response
Preset 4
Key Path
Meas Setup, Avg Number
Mode Stimulus / Response
Key Path
Meas Setup, Clear Calibration
To Next Page
Loading...
