196 Chapter 3
Mode
One Port Insertion Loss Measurement
Mode
2nd Segment (Left or Right Limits)
Sets to allow definition of the limits Left or Right of the center segment for the 2
nd
Segment. The Left or Right
amplitude limits can be changed with the
Level key. This key is only available when 2
nd
has been selected with
the Segments key.
Mode Stimulus / Response
Notes
Key is only displayed when the selected segment is 2
nd
.
Dependencies /
Couplings
If Off the 2
nd
limit mask segment will not be displayed even if
turned On.
If On, and the First and Center segments are On:
The left hand side 2
nd
segment is drawn to the left hand side of
the left first segment at the specified power level
The right hand side 1
st
segment is drawn to the right hand side
of the right first segment at the specified power
The segment spans are calculated as documented in section
above
Preset Off
State Saved Saved in instrument state.
Range On | Off
Key Path
Meas Setup, Limits, Limit Masks, Limit Mask 1, 2nd Segment
Mode Stimulus / Response
Notes
Key is only displayed when the selected segment is 2
nd
.
To Next Page
Loading...
