260 Chapter 4
Utility and Control/Sweep Functions
Utility Functions
Utility and Control/Sweep Functions
By Name Sorts and displays the current file catalog. The files are sorted in alphabetical
order according to filename.
By Extension Sorts and displays the current file catalog, in alphabetical order, by the file
extension of the file names (for example: .trc, .sta).
By Size Sorts and displays the current file catalog by the size of the files.
Order Changes the order of the display of the current file catalog.
Destination
When Type is set to Trace, Destination allows you to direct your data to Trace 1, Trace 2,
Trace 3, or Trace 4 for a single-trace file. If the data is for all four traces (Source was All
when they were saved), the data will be returned to the original trace registers, regardless
of the
Destination setting.
For any other Recall type,
Destination is disabled (grayed out).
Mode All
Key Path
Recall, Sort, By Name
Mode All
Key Path
Recall, Sort, By Extension
Mode All
Key Path
Recall, Sort, By Size
Mode All
Key Path
Recall, Sort, Order
Mode All
Preset Not affected by Preset. Power up and Restore Sys Defaults sets
Trace 1.
To Next Page
Loading...
