Chapter 4 271
Utility and Control/Sweep Functions
Utility Functions
Utility and Control/Sweep Functions
Prompt If the analyzer detects the file name already exists, a screen will be displayed asking you
if you want to Overwrite the existing file or append the new data onto the existing file data.
Auto Incr If the analyzer detects the file name already exists, numeric characters will be added to
the file name or existing numeric characters will be incremented to the next higher number.
Timestamp If the analyzer detects the file name already exists, a timestamp date and time will be
added to the file name.
Location
When you have selected a save type of Screen or Measurement Results, a screen listing the
attached USB drives is displayed. Thus enabling you to select where you want to save the
file when
Save Now is pressed. (The drives are shown at the root level only; subdirectories
cannot be selected.)
When you have selected a save type of State, a screen is displayed that enables you to save
the state normally to the internal drive or export the state to a USB device.
Mode All
Key Path
Save, Name, If File Exists…, Append
Mode All
Key Path
Save, Name, If File Exists…, Prompt
Mode All
Key Path
Save, Name, If File Exists…, Auto Incr
Mode All
Key Path
Save, Name, If File Exists…, Timestamp
Mode All
Preset Location survives Factory Preset, *RST, and power on.
Key Path
Save, Location
To Next Page
Loading...
