276 Chapter 4
Utility and Control/Sweep Functions
Utility Functions
Utility and Control/Sweep Functions
Date Format Enables you to set the date display to month-day-year or day-month-year. It is set to
a month-day-year format when the instrument System Defaults are restored. This key only effects
display of date at the top of the screen, not in the file catalog.
Set Time Enables you to set the time of the real-time clock. Enter the time in 24 hour HHMMSS
format.
Mode All
Remote Command :DISPlay:ANNotation:CLOCk:DATE:FORMat MDY|DMY
:DISPlay:ANNotation:CLOCk:DATE:FORMat?
Example DISP:ANN:CLOC:DATE:FORM DMY
Preset MDY
State Saved Survives Preset and power cycle, but not saved in Instrument
State.
Key Path
System, Time/Date/Location, Time/Date, Date Format
Mode All
Remote Command :SYSTem:TIME <hour>,<minute>,<second>
:SYSTem:TIME?
Example SYST:TIME 12,42,00 Sets the clock to 12:42:00 PM.
Preset Not affected by Preset. Depends on the time of the day.
State Saved Survives Preset and power cycle, but not saved in Instrument
State.
Range Hour (HH): 00 to 23
Minute (MM): 00 to 59
Second (SS): 00 to 59
Key Path
System, Time/Date/Location, Time/Date, Set Time
To Next Page
Loading...
