Agilent Technologies N1996A-503 - Page 282

282 Chapter 4
Utility and Control/Sweep Functions
Utility Functions
Utility and Control/Sweep Functions
30 min., 45 min., or 60 min.
Screen Save (Ext DC) Displays the table used to set the screen saver function to active and the
time delay before the screen saver activates. You use this key to set the time delay when you are
operating the analyzer on external DC power supply. You can set Screen Save to Disabled, or to
enabled with time intervals of 15 s., 30 s., 1 to 5 min. (in 1 min. intervals), 10 min., 15 min., 30 min.,
45 min., or 60 min.
System Stats
Displays the System Stats menu that enables you to View the following analyzer System
Statistics:
• Check analyzer system software version
• Check analyzer memory size and availability
• Check analyzer battery status
•Verify copyrights
Mode All
Preset Not affected by Preset.
State Saved Survives Preset and power cycle, but not saved in Instrument
State.
Range 15 s., 30 s., 1 min., 2 min., 3 min., 4 min., 5 min., 10 min., 15 min.,
30 min., 45 min., or 60 min., Disabled
Key Path
System, Control, Display Settings, Screen Save (Battery)
Mode All
Preset Not affected by Preset.
State Saved Survives Preset and power cycle, but not saved in Instrument
State.
Range 15 s., 30 s., 1 min., 2 min., 3 min., 4 min., 5 min., 10 min., 15 min.,
30 min., 45 min., or 60 min., Disabled
Key Path
System, Control, Display Settings, Screen Save (Ext DC)
Mode All
Key Path
System, System Stats