Chapter 4 291
Utility and Control/Sweep Functions
Utility Functions
Utility and Control/Sweep Functions
When you save a state to be used as the User Preset power-up state, you must name the
state “Powerup”. If you want to use the Agilent-defined defaults at power-up, press Mode
Preset to restore the Agilent-defined defaults and save that state as a new Powerup state
file.
Mode All
Remote Command :SYSTem:PRESet:USER
Example SYST:PRES:USER
Remote Command Notes Restores the state you have saved using the Save State key or
:SYSTem:PRESet[:USER]:SAVE command.
To Next Page
Loading...
