Alcatel-Lucent 7210 SAS M - Page 318

Command Hierarchies
Page 318 7210 SAS M, T, X, R6 Basic System Configuration
System Resource-Profile Commands
configure
— system
— resource-profile
— g8032-fast-flood-enable (applicable only on 7210 SAS-M devices)
— no g8032-fast-flood-enable
— decommission
— entry entry-id port port-range to port-range
— no entry entry-id
— egress-internal-tcam
— acl-sap-egress [num-resources]
— no acl-sap-egress
— [no] ipv6-128bit-match-enable num-resources
— mac-ipv4-match-enable num-resources
— no mac-ipv4-match-enable
— mac-ipv6-64bit-match-enable num-resources
— no mac-ipv6-64bit-match-enable
— mac-match-enable num-resources
— no mac-match-enable
— ingress-internal-tcam
— acl-sap-ingress [num-resources]
— no acl-sap-ingress
— ipv4-ipv6-128-match-enable num-resources
— no ipv4-ipv6-128-match-enable
— ipv4-match-enable num-resources
— no ipv4-match-enable
— ipv6-64-only-match-enable num-resources
— no ipv6-64-only-match-enable
— mac-match-enable num-resources (supported only on 7210 SAS-M and 7210
SAS-T devices)
— no mac-match-enable
— eth-cfm [num-resources]
— no eth-cfm
— up-mep num-resources
— no up-mep
— g8032-fast-flood-enable (applicable only on 7210 SAS-T devices)
— no g8032-fast-flood-enable
— no qos-sap-ingress-resource
— qos-sap-ingress-resource num-resources
— ipv4-mac-match-enable num-resources
— no ipv4-mac-match-enable
— ipv4-match-enable num-resources
— no ipv4-match-enable
— ipv6-ipv4-match-enable num-resources
— no ipv6-ipv4-match-enable
— mac-match-enable num-resources
— no mac-match-enable
— no sap-aggregate-meter
— sap-aggregate-meter num-resources
— [no] max-ipv6-routes number
— qos
— no sap-ingress-queues (supported only on 7210 SAS-X)
— sap-ingress-queues highUcastLowMcast
— mbs-pool {node|port}