Network QoS Policies
Quality of Service Guide 109
Parameters protocol protocol-id — Specifies an IP protocol to be used as an ingress network QoS policy
match criterion.
The protocol type such as TCP / UDP / OSPF is identified by its respective protocol number.
Well-known protocol numbers include ICMP(1), TCP(6), UDP(17).
Values protocol-id: 0 to 255 protocol numbers accepted in DHB
keywords: none, crtp, crudp, egp, eigrp, encap, ether-ip, gre, icmp,
idrp, igmp, igp, ip, ipv6, ipv6-frag, ipv6-icmp, ipv6-no-nxt, ipv6-
opts, ipv6-route, isis, iso-ip, l2tp, ospf-igp, pim, pnni, ptp, rdp,
rsvp, stp, tcp, udp, vrrp
* — udp/tcp wildcard
Table 20: Protocol ID descriptions
Protocol Protocol ID Description
icmp 1 Internet Control Message
igmp 2 Internet Group Management
ip 4 IP in IP (encapsulation)
tcp 6 Transmission Control
egp 8 Exterior Gateway Protocol
igp 9 any private interior gateway (used by Cisco for their IGRP)
udp 17 User Datagram
rdp 27 Reliable Data Protocol
ipv6 41 IPv6
ipv6-route 43 Routing Header for IPv6
ipv6-frag 44 Fragment Header for IPv6
idrp 45 Inter-Domain Routing Protocol
rsvp 46 Reservation Protocol
gre 47 General Routing Encapsulation
ipv6-icmp 58 ICMP for IPv6
ipv6-no-nxt 59 No Next Header for IPv6
ipv6-opts 60 Destination Options for IPv6
iso-ip 80 ISO Internet Protocol
eigrp 88 EIGRP
ospf-igp 89 OSPFIGP
To Next Page
Loading...
