Network QoS Policy Command Reference
110 Quality of Service Guide
match
Syntax match [next-header next-header]
no match
Context config>qos>network>ingress>ipv6-criteria>entry
Description This command creates a context to configure match criteria for a network QoS policy match IPv6
criteria. When the match criteria have been satisfied the action associated with the match criteria is
executed.
If more than one match criteria (within one match statement) are configured, then all criteria must be
satisfied (AND function) before the action associated with the match is executed.
A match context can consist of multiple match criteria, but multiple match statements cannot be
entered per entry.
It is possible that a network ingress policy includes the dscp map command, the dot1p map command,
and an IPv6 match criteria. When multiple matches occur for the traffic, the order of precedence is used
to arrive at the final action. The order of precedence is as follows:
802.1p bits
•DSCP
• IP Quintuple
The no form of this command removes the match criteria for the entry-id.
ether-ip 97 Ethernet-within-IP Encapsulation
encap 98 Encapsulation Header
pnni 102 PNNI over IP
pim 103 Protocol Independent Multicast
vrrp 112 Virtual Router Redundancy Protocol
l2tp 115 Layer Two Tunneling Protocol
stp 118 Schedule Transfer Protocol
ptp 123 Performance Transparency Protocol
isis 124 ISIS over IPv4
crtp 126 Combat Radio Transport Protocol
crudp 127 Combat Radio User Datagram
Table 20: Protocol ID descriptions (Continued)
Protocol Protocol ID Description
To Next Page
Loading...
