Service SAP QoS Policy Command Reference
254 Quality of Service Guide
Description This command sets the ip-criteria and ipv6-criteria type to control the type of match entries
configurable in this context.
Default normal
Parameters filter-type — Specifies which type of entries that the ip-criteria and ipv6-criteria statements can
contain.
Values normal — Regular match criteria are allowed; VXLAN VNI
matching is not allowed.
vxlan-vni — Matching is allowed on a VXLAN VNI for VXLAN
and VXLAN GPE frames.
The type cannot be changed when ip-criteria or ipv6-criteria
entries are configured. If there are no ip-criteria or ipv6-criteria
entries configured, the type can be changed from vxlan-vni to
normal. The type can only be changed from normal to vxlan-vni
if there are no ip-criteria or ipv6-criteria entries configured and
if the SAP ingress QoS policy has not been applied to any object
A SAP ingress QoS policy configured with type vxlan-vni can be
applied to any Ethernet SAPs, except for a PW-SAP, B-VPLS
SAP, or CCAG SAP, in any applicable service. This feature is
supported on FP2- and higher-based hardware.
type
Syntax type filter-type
no type
Context config>qos>sap-ingress>mac-criteria
Description This command sets the mac-criteria type.
Default normal
Parameters filter-type — Specifies which type of entries this MAC filter can contain.
Values normal — Regular match criteria are allowed; ISID match not
allowed.
vid — Configures the VID filter type used to match on ethernet_II
frame types. This allows matching VLAN tags for explicit
filtering.
lsp-exp
Syntax lsp-exp lsp-exp-value [fc fc-name] [priority {low | high}] [hsmda-counter-override
counter-id]
no lsp-exp lsp-exp-value
To Next Page
Loading...
