Service Egress and Ingress QoS Policies
Quality of Service Guide 253
This command is used to enter the node to create or edit policy entries that specify IPv6 criteria such
as IP quintuple lookup or DiffServ code point.
The OS implementation will exit on the first match found and execute the actions in accordance with
the accompanying action command. For this reason entries must be sequenced correctly from most to
least explicit.
This is supported on FP2- and higher-based line cards and requires mixed-mode for the 7450 ESS.
The no form of this command deletes all the entries specified under this node. Once ipv6-criteria
entries are removed from a SAP ingress policy, the ipv6-criteria is removed from all services where
that policy is applied.
renum
Syntax renum old-entry-number new-entry-number
Context config>qos>sap-ingress>ip-criteria
config>qos>sap-egress>ip-criteria
config>qos>sap-ingress>ipv6-criteria
config>qos>sap-egress>ipv6-criteria
config>qos>sap-ingress>mac-criteria
config>qos>network>ingress>ip-criteria
config>qos>network>ingress>ipv6-criteria
Description This command renumbers existing QoS policy criteria entries to properly sequence policy entries.
This can be required in some cases since the router exits when the first match is found and executes
the actions in accordance with the accompanying action command. This requires that entries be
sequenced correctly from most to least explicit.
Parameters old-entry-number — Enter the entry number of an existing entry.
Default none
Values 1 to 65535
new-entry-number — Enter the new entry-number to be assigned to the old entry.
Default none
Values 1 to 65535
type
Syntax type filter-type
no type
Context config>qos>sap-ingress>ip-criteria
config>qos>sap-ingress>ipv6-criteria
To Next Page
Loading...
