Service Egress and Ingress QoS Policies
Quality of Service Guide 289
unknown-queue
Syntax unknown-queue queue-id [group queue-group-name]
no unknown-queue
Context config>qos>sap-ingress>fc
Description This command overrides the default unknown unicast forwarding type queue mapping for fc fc-name.
The specified queue-id must exist within the policy as a multipoint queue before the mapping can be
made. Once the forwarding class mapping is executed, all unknown traffic on a SAP using this policy
is forwarded using the queue-id.
The unknown forwarding type usually tracks the multicast forwarding type definition. This command
overrides that default behavior.
The no form of this command sets the unknown forwarding type queue-id back to the default of
tracking the multicast forwarding type queue mapping.
Parameters queue-id — Specifies an existing multipoint queue defined in the config>qos>sap-ingress
context.
Values Any valid multipoint queue-id in the policy including 2 through
32.
Default 11
group queue-group-name — This optional parameter is used to redirect the forwarding type
within the forwarding class to the specified queue-id within the queue-group-name. When the
policy is applied, all packets matching the forwarding class and forwarding type will be
redirected to the queue within the specified queue group. The queue-group-name are
configured in the config>qos>queue-group-templates egress and ingress contexts.
queue
Syntax queue queue-id [{group queue-group-name [instance instance-id] | port-redirect-group-
queue} ]
no queue
Context config>qos>sap-ingress>fc
config>qos>sap-egress>fc
Description This command overrides the default queue mapping for fc fc-name. The specified queue-id must exist
within the policy before the mapping can be made. Once the forwarding class mapping is executed, all
traffic classified to fc-name on a SAP using this policy.
The no form of this command sets the queue-id back to the default queue for the forwarding class
(queue 1).
Default no queue
To Next Page
Loading...
