Service SAP QoS Policy Command Reference
290 Quality of Service Guide
Parameters queue-id — Specifies the SAP egress queue-id to be associated with the forwarding class. The
queue-id must be an existing queue defined in sap-egress policy-id.
Values 1 — 8
Default 1
group queue-group-name — This optional parameter is used to redirect the forwarding type
within the forwarding class to the specified queue-id within the queue-group-name. When the
policy is applied, all packets matching the forwarding class and forwarding type will be
redirected to the queue within the specified queue group. The queue-group-name are
configured in the config>qos>queue-group-templates egress and ingress contexts. This
parameter is used when policy based queue group redirection is desired. That is, the specific
queue group to redirect to is named in the QoS policy.
instance instance-id — This parameter is used to specify the specific instance of a queue group
with template queue-group-name to which this queue should be redirected. This parameter is
only valid for queue groups on egress ports where policy based redirection is required.
Values 1 to 40960
Default 1
port-redirect-group-queue — This keyword is used to mark a given forwarding class queue for
redirection to an egress queue group queue. This is only used when the specific queue group
instance is assigned at the time the QOS policy is applied to the SAP. This redirection model
is known as SAP based redirection.
hsmda-queues
Syntax hsmda-queues
Context config>qos>sap-egress
Description This command enables the context to configure queue definitions for use on SAPs or subscribers on
HSMDAs. A single QoS policy simultaneously defines queues for both standard MDA and for
HSMDA subscribers and SAPs. This allows the policy association decision to be ignorant of the type
of hardware the SAP or subscriber is traversing.
queue
Syntax queue queue-id [port-redirect-group-queue]
no queue queue-id
Context config>qos>sap-egress>hsmda-queues
To Next Page
Loading...
