Service Egress and Ingress QoS Policies
Quality of Service Guide 321
Service Egress QoS Policy Forwarding Class Commands
fc
Syntax fc fc-name
no fc fc-name
Context config>qos>sap-egress
Description The fc fc-name node within the SAP egress QoS policy is used to contain the explicitly defined queue
mapping and dot1p marking commands for fc-name. When the mapping for fc-name points to the
default queue and the dot1p marking is not defined, the node for fc-name is not displayed in the show
configuration or save configuration output unless the detail option is specified.
The no form of the command removes the explicit queue mapping and dot1p marking commands for
fc-name. The queue mapping reverts to the default queue for fc-name and the dot1p marking (if
appropriate) uses the default of 0.
Default none
Parameters fc-name — This parameter specifies the forwarding class queue mapping or dot1p marking is to
be edited. The value given for fc-name must be one of the predefined forwarding classes in
the system.
Values be, l2, af, l1, h2, ef, h1, nc
parent-location
Syntax parent-location {default | sla}
no parent-location
Context config>qos>sap-egress
Description This command determines the expected location of the parent schedulers for queues configured with
a parent command within the sap-egress policy. All parent schedulers must be configured within a
scheduler-policy applied at the location corresponding to the parent-location parameter.
If a parent scheduler name does not exist at the specified location, the queue will not be parented and
will be orphaned.
The no form of the command reverts to the default.
Default default
Parameters default — When the sap-egress policy is applied to an sla-profile for a subscriber, the parent
schedulers of the queues need to be configured in the scheduler-policy applied to the
subscriber’s sub-profile.
To Next Page
Loading...
