Service Egress and Ingress QoS Policies
Quality of Service Guide 347
This command is supported on FP2 and higher based hardware, and is otherwise ignored.
Default 0
Parameters dot1p-value — Specifies the 802.1p value to set for in-profile frames in this forwarding class.
Values 0 to 7
in-profile dot1p-value — Specifies the 802.1p value to set for in-profile frames in this forwarding
class.
Values 0 to 7
out-profile dot1p-value — specifies the 802.1p value to set for out-profile frames in this
forwarding class.
Values 0 to 7
exceed-profile dot1p-value — specifies the 802.1p value to set for exceed-profile frames in this
forwarding class.
Values 0 to 7
description
Syntax description string
no description
Context config>qos>match-list>ip-prefix-list
Description This command creates a text description stored in the configuration file for a configuration context.
The description command associates a text string with a configuration context to help identify the
context in the configuration file.
The no form of the command removes any description string from the context.
Default none
Parameters string — The description character string. Allowed values are any string up to 80 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
match-list
Syntax match-list
Context config>qos
Description This command enables the configuration context for match lists to be used in QoS policies.
To Next Page
Loading...
