Service SAP QoS Policy Command Reference
348 Quality of Service Guide
ip-prefix-list
Syntax ip-prefix-list ip-prefix-list-name [create]
no ip-prefix-list ip-prefix-list-name
Context config>qos>match-list
Description This command creates a list of IPv4 prefixes for match criteria in QoS policies.
An ip-prefix-list must contain only IPv4 address prefixes created using the prefix command and cannot
be deleted if it is referenced by a QoS policy.
The no form of this command deletes the specified list.
Parameters ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
characters are used, the string must be enclosed within double quotes.
prefix
Syntax prefix ip-prefix/prefix-length
no prefix ip-prefix/prefix-length
Context config>qos>match-list>ip-prefix-list
Description This command adds an IPv4 address prefix to an existing IPv4 address prefix match list.
The no form of this command deletes the specified prefix from the list.
To add set of unique prefixes, execute the command with all unique prefixes. The prefixes are allowed
to overlap IPv4 address space.
An IPv4 prefix addition will be blocked, if resource exhaustion is detected anywhere in the system
because of QoS Policies that use this IPv4 address prefix list.
Default none
Parameters ip-prefix — A valid IPv4 address prefix in dotted decimal notation.
Values 0.0.0.0 to 255.255.255.255 (host bit must be 0)
prefix-length — Length of the entered IP prefix
Values 1 to 32
To Next Page
Loading...
