QoS Queue Group Template Command Reference
502 Quality of Service Guide
reference-rate — When a reference-rate value is specified, the rate-per-second for each statistic
is displayed as a percentage based on the reference rate specified.
Values 100M, 1G, 10G, 40G, 100G, 400G
arbiter name — Specify the name of the policer control policy arbiter.
Values An existing arbiter-name in the form of a string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
root — Specifies the root arbiter.
port
Syntax port port-id egress network queue-group queue-group-name instance instance-id [interval
seconds] [repeat repeat] [absolute | rate] [arbiter root | name]
Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics in an egress port queue group.
Parameters port port-id —
Values slot/mda/port
egress network — Specifies statistics are for an egress network queue group.
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters in
length.
instance instance-id — Specifies the identification of a specific instance of the queue-group.
Values 1to 65535
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
port-id slot/mda/port [.channel]
eth-sat-id esat-id/slot/port
esat keyword
id 1 to 20
pxc-id pxc-id.sub-port
pxc keyword
id 1 to 64
sub-port a, b
To Next Page
Loading...
