Queue Sharing and Redirection
Quality of Service Guide 503
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed.
arbiter name — Specify the name of the policer control policy arbiter.
Values An existing arbiter-name in the form of a string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string
contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
root — Specify the root arbiter.
port
Syntax port port-id queue-group queue-group-name [ingress | egress] [interval seconds] [repeat
repeat] [absolute | rate] [access | network] [instance instance-id]
Context monitor>qos>scheduler-stats
Description This command enables port traffic monitoring.
Parameters port port-id — Specifies the port ID.
Values
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters in
length.
instance instance-id — Specifies the identification of a specific instance of the queue-group.
Values 1 to 65535
ingress — Specifies statistics are for an ingress queue group.
egress — Specifies statistics are for an egress queue group.
port-id slot/mda/port [.channel]
eth-sat-id esat-id/slot/port
esat keyword
id 1 to 20
pxc-id pxc-id.sub-port
pxc keyword
id 1 to 64
sub-port a, b
To Next Page
Loading...
