Shared-Queue QoS Policies
Quality of Service Guide 659
fc
Syntax [no] fc fc-name
Context config>qos>shared-queue
Description This command specifies the forwarding class name. The forwarding class name represents an egress
queue. The fc fc-name represents a CLI parent node that contains sub-commands or parameters
describing the egress characteristics of the queue and the marking criteria of packets flowing through
it. The fc command overrides the default parameters for that forwarding class defined in the network
default policy policy-id 1.
Default See Default Shared Queue Policy Values for undefined forwarding class values.
Parameters fc-name — The case-sensitive, system-defined forwarding class name for which policy entries
will be created.
Values {be | l2 | af | l1 | h2 | ef | h1 | nc}
Default none
broadcast-queue
Syntax broadcast-queue multipoint-queue-id
Context config>qos>shared-queue>fc
Description This command configures the broadcast forwarding type queue mapping for fc fc-name. The specified
queue-id must exist within the policy as a multipoint queue before the mapping can be made. Once the
forwarding class mapping is executed, all broadcast traffic on a SAP using this policy will be
forwarded using the queue-id.
The broadcast forwarding type usually tracks the multicast forwarding type definition. This command
overrides that default behavior.
The no form of the command sets the broadcast forwarding type queue-id back to the default of
tracking the multicast forwarding type queue mapping.
Parameters multipoint-queue-id — The multipoint-queue-id parameter must be an existing, multipoint queue
defined in the config>qos>sap-ingress context policer-output-queues profile. For the 7950
XRS, this is not configurable in the policer-output-queues profile.
Values 17 to 24
multicast-queue
Syntax multicast-queue queue-id
Context config>qos>shared-queue>fc
To Next Page
Loading...
