Shared-Queue QoS Policy Command Reference
660 Quality of Service Guide
Description This command configures the multicast forwarding type queue mapping for fc fc-name. The specified
queue-id must exist within the policy as a multipoint queue before the mapping can be made. Once the
forwarding class mapping is executed, all multicast traffic on a SAP using this policy is forwarded
using the queue-id.
The multicast forwarding type includes the unknown unicast forwarding type and the broadcast
forwarding type unless each is explicitly defined to a different multipoint queue. When the unknown
and broadcast forwarding types are left as default, they will track the defined queue for the multicast
forwarding type.
The no form of the command sets the multicast forwarding type queue-id back to the default queue for
the forwarding class. If the broadcast and unknown forwarding types were not explicitly defined to
a multipoint queue, they will also be set back to the default multipoint queue (queue 11).
Parameters queue-id — The queue-id parameter specified must be an existing, multipoint queue defined in the
the config>qos>sap-ingress context policer-output-queues profile. For the 7950 XRS, this is
not configurable in the policer-output-queues profile.
Values 9 to 16
Default 11
queue
Syntax queue queue-id
no queue
Context config>qos>shared-queue>fc
Description This command overrides the default unicast forwarding type queue mapping for fc fc-name. The
specified queue-id must exist within the policy as a non-multipoint queue before the mapping can be
made. Once the forwarding class mapping is executed, all unicast traffic (this includes all traffic, even
broadcast and multicast for services) on a SAP using this policy is forwarded using the queue-id.
The no form of this command sets the unicast (point-to-point) queue-id back to the default queue for
the forwarding class (queue 1).
Parameters queue-id — The queue-id parameter specified must be an existing, non-multipoint queue defined
in the config>qos>sap-ingress context. For the 7950 XRS, this is not configurable in the
policer-output-queues profile.
Values Any valid non-multipoint queue-id in the policy including 1 and 3
through 32.
Default 1
queue
Syntax queue queue-id [queue-type] [profile-mode | priority-mode] [multipoint] pool pool-name
To Next Page
Loading...
