QoS ATM Traffic Descriptor Profiles
Quality of Service Guide 705
Parameters type — defines interpretation of traffic parameters that are specified for this profile
Values P0_1, P0_1andS0_Tag, P0_1andS0, P0_1andS0_1
Table 51 details these rules.
Setting descriptor type to a value not compatible with the service category (as defined in the
above table) is an error.
policing
Syntax [no] policing
Context config>qos>atm-td-profile
Description This command determines whether ingress traffic is policed. Policing is valid for CBR, RT-VBR and
NRT-VBR. This is cell-based policing.
Default disabled
UBR P0_1
UBR with MIR P0_1
rt-VBR or nrt-VBR P0_1andS0_1
Table 50: Descriptor Type Default Values (Continued)
Service Category Default Descriptor Type
Table 51: Descriptor Type Rate Interpretations
Descriptor Type Rates Interpretation Applicable Service Categories
P0_1 PIR applies to CLP=0 and
CLP=1 cell flows
CBR, UBR, UBR with MIR
P0_1andS0_1 PIR applies to CLP=0 and
CLP=1 cell flows
SCR applies to CLP=0 and
CLP=1 cell flows
rt-VBR and nrt-VBR
P0_1andS0 PIR applies to CLP=0 and
CLP=1 cell flows
SCR applies to CLP=0 cell
flow
rt-VBR and nrt-VBR
To Next Page
Loading...
